M393T2863AZA Datasheet

 
Edited by (http://www.seekic.com/),the leading IC purchasers' best choice of platform for one-stop valued service!
Features:
• JEDEC standard 1.8V ± 0.1V Power Supply
• VDDQ = 1.8V ± 0.1V
• 200 MHz fCK for 400Mb/sec/pin, 267MHz fCK for 533Mb/sec/pin, 333MHz fCK for 667Mb/sec/pin
• 8 Banks
• Posted CAS
• Programmable CAS Latency: 3, 4, 5
• Programmable Additive Latency: 0, 1 , 2 , 3 and 4
• Write Latency(WL) = Read Latency(RL) -1
• Burst Length: 4 , 8 (Interleave/nibble sequential)
• Programmable Sequential / Interleave Burst Mode
• Bi-directional Differential Data-Strobe (Single-ended data-strobe is an optional feature)
• Off-Chip Driver(OCD) Impedance Adjustment
• On Die Termination with selectable values(50/75/150 ohms or disable)
• PASR(Partial Array Self Refresh)
• Average Refresh Period 7.8us at lower than a TCASE 85°C, 3.9us at 85°C < TCASE < 95 °C
  - support High Temperature Self-Refresh rate enable feature
• Serial presence detect with EEPROM
• DDR2 SDRAM Package: 68ball FBGA - 256Mx4/128Mx8, 56ball BGA - st.512Mbx4
• All of Lead-free products are compliant for RoHS

(Absolute) Maximum Ratings:
Symbol Parameter Rating Units Notes
VDD Voltage on VDD pin relative to VSS - 1.0 V ~ 2.3 V V 1
VDDQ Voltage on VDDQ  pin relative to VSS - 0.5 V ~ 2.3 V V 1
VDDL Voltage on VDDL pin relative to VSS - 0.5 V ~ 2.3 V V 1
VIN, VOUT Voltage on any pin relative to VSS - 0.5 V ~ 2.3 V V 1
TSTG Storage Temperature -55 to +100 °C 1, 2
Note :
1. Stresses greater than those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. This is a stress rating only and functional operation of the device at these or any other conditions above those indicated in the operational sections of this specification is not implied. Exposure to absolute maximum rating conditions for extended periods may affect reliability.
2. Storage Temperature is the case surface temperature on the center/top side of the DRAM. For the measurement conditions, please refer to JESD51-2 standard